Honda Goldwing Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
364 Posts
Discussion Starter #1
I have a friend that has a small shop and does my tire work for me he has a 1987 1200 engine that he is trying to install a new stater. He needs to find out what tool is used to remove the large nut on drive shaft at rear of engine. I think it holds the drive shaft spline while you get the nut lose anybody have any ideas what it takes? Hal
 

·
Administrator
Joined
·
26,270 Posts
I went through the shop manual and couldn't find any mention about removal tool or the size of the nut, and had no luck in the parts section either. It's been so long since I changed out the stator in my 1200 I forget most of what I learned, sorry. Maybe someone with a better memory than me has done one and can recall the nut size.
 

·
Registered
Joined
·
364 Posts
Discussion Starter #3
Thanks budoka Ill let him know I could not find anything about it either. Hal
 
1 - 3 of 3 Posts
Top