Honda Goldwing Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
620 Posts
Discussion Starter · #1 ·
I didn't like the foot boards with heel toe shifter so I baught peg lowering kit and a Kury. brake lvr. Love it. more leg room. However thhe stock shift peg is up under the valve cover and hard to reach with my big foot. I had to reach up and in to shift. So- I remo9ved the rubber from it, cut a piece of brass 9/16 tube and shimed up the shift shaft where the peg rubber was then glued a piece of 3/8 heater hose on the tube. Works great.
Now the controls are just where I like them. Now I need to clean up Red and polish her.
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top