Honda Goldwing Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
I recently took my fairings off my 1983 goldwing 1100 Interstate and i bought some new turn signals and they only have two wires unlike my old ones wich have three. they will power on but turn off when i turn the signal on, i bought a two pole automotive relay and it works just like the old one, does anyone know hoiw to wire newer turn signals with only two wires? thanks
 

·
Super Moderator
Joined
·
7,671 Posts
Have looked at the 1983 schematic and it shows three wires, one is for the 'Position' light and the other is for the turn signal and then last you have ground.
Two wires means ground and one for the turn signal.
Find the ground wire on the bike and the turn signal hot wire and tie them to the correct wires on the new fixture.
 
1 - 2 of 2 Posts
Top