Honda Goldwing Forum banner

21 - 23 of 23 Posts

·
Super Moderator
Joined
·
11,951 Posts
So how did you remove the lugs with no one to hold the brake? I don't have a swivel ratchet so clearance may be an issue for me? Total rookie on this and I can't lay the bike over in the garage to check it out. I'm going to get through it, but I have some worries about it.
I had mine in gear, used a breaker bar with a deep socket to loosen and the torque wrench to tighten .
 
  • Like
Reactions: JKWinger

·
Premium Member
Joined
·
2,506 Posts
Discussion Starter #22
So how did you remove the lugs with no one to hold the brake? I don't have a swivel ratchet so clearance may be an issue for me? Total rookie on this and I can't lay the bike over in the garage to check it out. I'm going to get through it, but I have some worries about it.
I just left it in gear.
 

·
Registered
Joined
·
1,182 Posts
That's what I did too. But I had an impact wrench for removal.
 
21 - 23 of 23 Posts
Top