Honda Goldwing Forum banner
Status
Not open for further replies.

Grommet Pin

2K views 12 replies 5 participants last post by  blk93wing 
Two guns NO!! do not use PVC glue. Go to lowes and find some ABS plastic it is black not white like pvc. They should also have ABS glue its made just for ABS plastic. I bought just the ABS couplings for ABS plastic pipe I did not need a 10ft piece of pipe just a little.
 
If you dont want your wife to kill you I suggest you dont use her good blender! I would get the pins from e_bay and then grind up some ABS plastic in a small glass bowel you dont need alot. Then add the ABS glue and mix it up use this as your base to put the new pin in.This will give it a much better base then just gluing it to the side cover. good luck Hal
 
If you use that blender you better sleep next to your bike with one eye open!!! And if we dont hear from you where should we send the posse to look for your remains haha. Just kiddin with you I think. Hal
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top