Honda Goldwing Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi Folks,

I am a Mini owner and want to put the engine from a downed and written off GL1800 into the car as an engine replacement project.

I have hunted for physical dimensions to do the pre-planning and layout, but can't find this anywhere so I'm hoping some bright chap may be able to assist.

I need the dimensions from:
front of oilfilter to the rear drive flange (front to rear)
head to head across the engine (width)
total height from bottom of sump to top of casings/airbox

I figure that using a legendary engine to replace a British hunk of leaky cast iron would be a good move :D
 
1 - 1 of 1 Posts
Top