Honda Goldwing Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
280 Posts
Discussion Starter #1 (Edited)
My eyesight isn't the best. Looks like it's "clipped' in but the whole thing is rubber. I didn't see a screw holding it down, but I'll peel back the cover on the side and take a better look. Any ideas?

Thanks,
Greg

OK, got it. It slides forward and off a metal tab.

Now if I could just get the inlet and outlet tubes off :)
 

·
Super Moderator
Joined
·
11,804 Posts
Put a small pair of needle nose pliers under the edge of the tubing and pry it off. Twisting it first to break the seal, helps a lot.
 

·
Registered
Joined
·
280 Posts
Discussion Starter #3
Put a small pair of needle nose pliers under the edge of the tubing and pry it off. Twisting it first to break the seal, helps a lot.
Yes, the twisting was the key. Thanks!

In case anybody is interested, here's a pic of the old and new fuel filter side by side... Can you pick out which is which? :)

 

·
Super Moderator
Joined
·
9,856 Posts
I"m going to go with the new "orange" one.
 
1 - 5 of 5 Posts
Top