Honda Goldwing Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
600 Posts
Discussion Starter · #1 ·
I did say some time back I was working on extentions for the brrake and front shift beddle. Here is what I came up with. It is bade of aluminum 1.75" wide/ 1/4 thick and 4" long. I would have put a better looking pad on it if I had a small bench lathe with a milling attachment. It sure makes iteasier to find with my foot
 

Attachments

·
Administrator
Joined
·
29,796 Posts
Opps, wrong pic. Here is the proper one.
Hey wolf that 2nd picture is definitely prettier.:D

Seriously, good job on the Fabwork.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top