Honda Goldwing Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
I am having trouble getting the local Honda dealer (actually they are having trouble) getting Honda to replace the sensor on my '93 GL1500SE. I would like to bypass the sensor so I can at least see if the bike will start to run some fuel through the carbs so they don't get fouled up. Can anyone tell me for sure how to do this? Thanks!
 

·
Registered
Joined
·
9 Posts
Discussion Starter #2
PROBLEM SOLVED!! After checking the engine stop switch, i found that the two screws connecting the wires to the switch were loose. I tightened the screws and the bike started on the first try. The bank angle sensor is bad, so i will be replacing that as well. Thanks!
 
1 - 2 of 2 Posts
Top