Honda Goldwing Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a 1984 1200 Aspencade. Clutch master cylinder is leaking at the site window. What can be done to fix this? I can't find the part.
 

·
Super Moderator
Joined
·
12,272 Posts
First of all, welcome to the forum. Have you tried eBay?
 

·
Super Moderator
Joined
·
15,167 Posts
hello mcweaver, welcome to GWOF
you can seal the sight glass with jb weld or if the glass itself is bad you can get a 17mm watch crystal and sand it to fit and jb weld it inplace after removing the old sight glass
 

·
Registered
Joined
·
72 Posts
Have read you can cut a disk; with a metal lathe; heat clutch;tap in frozen disk.
Used to have name of guy who did this; but can't find.
Triwing
 

·
Premium Member
Joined
·
7,982 Posts
I'd first drain the brake fluid to below the site glass, clean it up to good clean and dry on outside and use a bead of gel super glue around the outside of the glass. After a brief drying time, maybe helped by a hair dryer on low heat, fill it back up to the line on the glass and shazam!

Have I mentioned I'm cheap?:eek::)
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top