Honda Goldwing Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
i know a thread exists, i just cant find it. ive got em almost out but i guess i need to remove a bowl or remove braces.not sure but no slide right out.
 

·
Registered
Joined
·
8 Posts
Discussion Starter #2
i got em out. you would not believe how bad they are varnished and gunked. the stuff was so thick the jet holes were smoothed over.the valve needles were stuck. i bought some carb cleaner with the basket and a few hours later they look good. im installing tomoro
 

·
Registered
Joined
·
91 Posts
Make sure to blow every hole/orifice through with compressed air. Nothing worse than putting it all back together then having to take them out again because you missed some tiny hole that is still gummed up..

Good luck

Gary
 
1 - 3 of 3 Posts
Top