Joined
·
19 Posts
Is there somebody out there that is able to repair gl 1200A ECM? I need it for my bike.
Can't find gl 1200A computer.
1 - 20 of 33 Posts
Joined
·
15,480 Posts
ebay is going to be your friend
Joined
·
1,319 Posts
Regarding repair. You know it’s possible. There are old bikes all over up here that could use one. And not just Hondas, but other brands too!! Good luck with your search. You might just shop for an entire parts bike to get a good one. Ten you would other obsolete parts too!
Joined
·
13,448 Posts
I would say a fuel injected, as the carburetor 1200s didn't even have an ECM.
After taking about 1/2 hour looking for this part, it is listed on the engine guard page. part #1
38770-ML8-751 CFI
Must stand for computerized fuel injection. I did find one page that had a price, $1500+.
Of course it's not available.
www.mrcycles.com
This SEI is the only model that shows any kind of ECM/ECU/CFI. Definitely need a year and model.
38770-ML8-751 CFI
Must stand for computerized fuel injection. I did find one page that had a price, $1500+.
Of course it's not available.
1986 Honda GL1200SEI A ENGINE GUARD | MRCycles
Shop online for OEM ENGINE GUARD parts that fit your 1986 Honda GL1200SEI A, search all our OEM Parts or call at 800.359.0567
www.mrcycles.com
This SEI is the only model that shows any kind of ECM/ECU/CFI. Definitely need a year and model.
Joined
·
10 Posts
Year is not stated.....I believe looking for 'Ignition Control Unit' ?
I mentioned that in post #2. Waiting for the OP to return. Also need the exact model. Only the SEI had a computer.
Joined
·
19 Posts
My bike is 1986 gl 1200A.
Joined
·
19 Posts
I've used a Chinese connector to the starter relay of my 1986 gl 1200A. The poles are reversed which killed the ECM. I've been constantly checking for ECM from ebay but no luck. I have 2 ECM. Both are defective. I'm mechanically inclined.
Joined
·
10 Posts
Above is the name of the item you're looking for, not ECM, it should be ICU
Have you tried Straightwings....
That's the one I saw also for a non SEI
Joined
·
5 Posts
There is a salvage yard near me that has a few of the GL1200s parted out not sure what is left give them a call. Motorcycle Salvage in Morristown Tn at 423-581-4699 maybe they can help.
I was able to repair a similar unit on an 89 K100. There are a couple of capacitors that tend to go bad. On that K bile, I was able to do it for $10 or so. Of course the large paper capacitors were a special order item, but I was able to get them from Digikey. It's been my experience that a lot of electronics get tossed when a couple of new capacitors could salvage them easily. Since caps have atomic level "moving" parts, they do wear out over time.
If you have any skill with a soldering iron, you might try looking for any funny looking capacitors to replace, or any can type capacitors that show any sign of deformation. It could be risky, but if it's already not working, might be worth a try.
If you have any skill with a soldering iron, you might try looking for any funny looking capacitors to replace, or any can type capacitors that show any sign of deformation. It could be risky, but if it's already not working, might be worth a try.
Joined
·
19 Posts
1 - 20 of 33 Posts
