Honda Goldwing Forum banner
1 - 1 of 1 Posts

'84 Goldwing Aspencade,,&,,'06 CFR450R
2 Posts
Discussion Starter · #1 ·
I can't get the splines to line up for the thing to fully get inside the drive.

So far I've got it in gear and have the bolt run thru all the way until the threads are showing...I could put the nut on if i needed, and still can't get the splines to align.

It apears to be right there but no matter how I jiggle turn and pull it just won't slide in all the way...I'm frustrated now...

There is some trick or am I just not doing this correctly....
1 - 1 of 1 Posts