Honda Goldwing Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Have a '84 Goldwing 1200 Aspencade and cannot get the clutch to hold pressure. Have bled the lines, but still no pressure. Do I need to replace the master and slave or do ya'll have any other suggestions. Thanking ya'll in advance.
Bob
 

·
Super Moderator
Joined
·
7,671 Posts
When you check the reservoir has the level dropped?
Do you find any fluid under the bike?
I would check the slave cylinder.
 

·
Registered
Joined
·
123 Posts
Before you do anything else, try bleeding it at the banjo nut on the clutch handle. Air gets trapped there at the top of the system and will cause the exact problem you're describing. Just loosen the nut, squeeze the handle gently (cover everything with rags first), then tighten while holding the handle in. Repeat as necessary (until no more air comes out). Worked like a charm for me.
 
1 - 3 of 3 Posts
Top